Public Service Commission Act, 1997
R 385
Civil Aviation Act, 2009 (Act No. 13 of 2009)RegulationsCivil Aviation Regulations, 2011Part 21 : Certification Procedures for Products and PartsSubpart 9 : Approval of Parts and Appliances21.09.4 Issuing of ZA-PMA |
| (1) | Subject to the provisions of subregulation (2), an application in terms of regulation 21.09.3 shall be granted and a ZA-PMA issued if— |
| (a) | the Director is satisfied, upon examination of the design and the results of all inspections and tests, that the design oomplies with the airworthiness design standards referred to in regulation 21.02.3, applicable to the product on which the part is to be installed; and |
| (b) | the applicant submits a statement certifying that the manufacturing inspection system referred to in regulation 21.09.2(3), has been established. |
| (2) | The Director shall not issue a ZA-PMA if the manufacturing facility for the part is located outside the Republic, unless the Director is satisfied that the location of such a facility will not impede the administration of the appropriate airworthiness requirements prescribed in this part. |
